banner
Home > Knowledge > Content
Products Categories
Contact Us
Tel: +86-510-88156399
Mob1: +8615852701809
Mob2: +8615951506886
Mob3: +8615952470757
Email: Zyc@cn-lxjt.com
Add: No.19, Feng Er Road, Xinwu District, Wuxi City, Jiangsu Province, China

What are some common mistakes in pressure vessel design?

Jun 19, 2026

I. Common Mistakes Regarding Major Safety Risks

These errors can cause serious safety hazards and are among the most critical and error-prone issues:

1. Incorrect classification of pressure vessels: Incorrectly classifying regulatory levels leads to mismatched design standards, creating potential safety hazards.

2. Incorrect strength/stiffness calculations of major pressure-bearing components: Design drawing parameters are significantly inconsistent with calculations, directly affecting load-bearing capacity.

3. Incorrect material selection for major pressure-bearing components: Materials that do not meet actual operating conditions will significantly reduce load-bearing capacity and may also cause cracks, corrosion, and brittle fracture.

4. Omissions or errors in important technical requirements: Direct non-compliance with mandatory regulatory requirements will lead to regulatory failure or operational malfunctions.

5. Incorrect structural design of major pressure-bearing components: This can cause severe stress concentration or instability, constituting a fundamental design error.

II. Common Mistakes Regarding General Technical Risks

These errors can cause certain safety hazards or cost waste:

1. Incorrect or omitted design parameters, improper vessel classification (misclassification of jurisdiction or overclassification). 2. Design output files do not meet design input requirements; incorrect standard selection for pressure-bearing components.

3. Incorrect or missing technical requirements for containers or pressure-bearing components; incorrect structural selection.

4. Missing steps or incorrect parameters in strength calculations; incorrect dimensioning on drawings.

5. Misuse or incorrect application of design specifications; use of outdated versions; misinterpretation of standard clauses; safety factors selected incompatible with operating conditions.

III. Low-Risk Common Mistakes

These errors do not constitute major safety hazards but will affect production and processing:

1. Inconsistent assembly dimensions with component dimensions; conflicting data for individual dimensions and angles;

2. Incorrect or missing selection or annotation of dimensional tolerances, geometric tolerances, and surface roughness;

3. Flange bolt holes not arranged according to requirements at mid-span; incorrect or missing pipe or support orientations;

4. Drafting specifications do not meet requirements; errors in text and annotations exist.

IV. Common Mistakes in Stress Analysis

The following errors commonly occur in finite element stress analysis:

1. Incorrect definition of the loading scenario, oversimplification of the geometric model, and neglect of thermal and cyclic stresses;

2. Incorrect boundary condition settings, which can lead to distorted stress concentration predictions and insufficient design safety margins.

Heat Pump Plate Heat Exchanger

Related Industry Knowledge

Related Products